General Application Guidelines
General Application Guidelines
- GUHER™ BONDPLUS penetration qualities wash down substrate with water.
- Never mix any product GUHER™ products, into material never thin with any other chemicals.
- Always stir or shake GUHER™ products before and during application.
-
GUHER™ dries as a clear membrane.
Mix 10% into GUHER™ COAT-EX into the GUHER™BONDPLUS to help with visibility of the application and to give better covering properly. - Where GUHER™ BONDLUS doesn’t penetrate the surface, scrub or sand GUHER™ BONDPLUS into the substrate while still wet using wire brush or 40 grit sand paper.
- Very smooth surfaces require second coat of GUHER™ BONDPLUS. Always sand the surface before applying GUHER™ BONDPLUS.
- Always apply at least two coats any top coat of GUHER™ Products.
- Seal all vertical walls next to concrete roofs at least 200/300mm, high to stop creeping underneath sealed surface.
- Expanding and contracting cracks must be sealed using a membrane. Ensure that the membrane enough play to take up movement of both surfaces in climatic change. Dry season will increase crack size and wet season decrease size.
- Small cracks can be filled with cement, sand and GUHER™ BONDPLUS mixture. Follow cement manufacturers specifications but replace water with GUHER™ BONDPLUS. This mixture will increase the elasticity of the dried product.
- Clean all the brushes, rollers spray guns with water, warm water can be used.
- If you have any doubts or unusual applications contact our GUHER™ Products Technical Engineer.